Termination Selector Guide
Standard leads:
Fiberglass insulated lead wires externally connected to nickel pins. The connections area is electrically insulated with heavy-wall fiberglass
sleeving.
12" Leads are standard
Swaged-in Flexible Leads
Fiberglass insulated lead wires are internally connected to nickel pins.
This design allows for great flexibility at the lead exit point of the heater.
12" Leads are standard
Teflon Leads & Seal
Teflon insulated lead wires with a teflon end seal swaged into the heater sheath provides a moisture resistant design. This design requires a minimum of 1” cold
section at lead exit end of heater.
12" Leads are standard
Internal Thermocouple
Type J thermocouple provides integral method for temperature control. Thermocouple junction (grounded or Ungrounded) can be located at the
end disc, center or lead end.
Please specify. Other thermocouple types are available.
Straight Braid Lead Protection
Stainless steel braid over fiberglass insulated lead wires exits straight from heater sheath for abrasion resistance.
3" additional lead beyond braid is standard.
Straight Armor Cable
Armor cable over fiberglass insulated lead wire exits straight from heater sheath for heavy duty lead protection.
3” lead beyond armor is standard. Specify galvanized or stainless steel armor when ordering.
Right Angle Armor Cable With Copper Elbow
Armor cable leads extend at right angle from heater with right angle copper elbow.
3” lead beyond armor is standard.
Specify: galvanized or stainless steel armor; length of heater sheath.
Immersion Pipe Fitting
Threaded NPT pipe fitting is silver soldered directly to heater sheath for immersion applications. Fiberglass insulated lead wires exit high temperature cement potting. 3/4” cold required before fitting.
| Specify: |
“MS” for Stainless fitting
“MB” for brass fitting
|
 |
Mounting Flange
Stainless steel flange welded directly to heater sheath. Fiberglass insulated lead wires are standard. Other flange sizes and hole patterns are available upon request.
Post Terminals
Threaded stainless steel terminals are welded directly to nickel pin for rigid mount applications. Includes two (2) nuts and washers for each terminal.
Previous Page / Next Page
